ShopSmith Mark V
Print This Article
A very versatile and functional tool, it is a table saw, horizontal boring machine, drill press, disk sander, and lathe. There are several additional attachments available for the system: band saw, scroll saw, planer, etc.
Several years ago my father-in-law purchased a ShopSmith from his brother-in-law. At the time he did not have space to store it so he allowed me to keep it for the winter, this discussion was in the fall, and in the following spring he would take it back. Well, that has been a few years now.
This ShopSmith was built back around 1978. The tool came with band saw and scroll saw attachments.
You can read more about the history of the ShopSmith tool system.
The beauty of this system is that the system is that they have kept the interface to the attachments and the motor the same. So, you can use attachments that were built twenty or thirty years ago with your system!
The Mark V model 500’s table was very small and the fence left much to be desired. I built a bathroom vanity with it and I felt I was reaching the maximum of what the table saw could handle (stock wise). My father-in-law and I decided to purchase the upgrade kit to bring it up to the Mark V model 520. The 520’s table and extension tables make it so much easier to use and handle larger stock.
The biggest draw back to the Shop Smith design is cutting 45 degree bevels. In order to cut the bevel the table tilts to a 45 degree. Ok. Now try ripping a 12” wide cut down the length of a 4×8 sheet of plywood. Not fun. I have contemplated it and altered my project’s design.
The project in question was kitchen cabinets. One of the projects that I built with the ShopSmith was an entire set of replacement kitchen cabinets. More on this in a future post.
The unit is solidly built with retractable wheels. This makes so much easier to move around the shop. The wheels are deployed and retracted via foot levers. Interestingly enough the designers chose to have two different heights that you can raise the ShopSmith up by.
Tip: To make the stock slide easier across the table, wax the table with a good quality floor wax. Follow the instructions on the container. It makes the stock slide much easier.
The motor is powerful enough to cut through a variety of hardwoods. The quality and type of saw blade will significantly impact the cutting performance. I have cut red oak, white oak, mahogany, birch, and other hard woods quite easily using a 30 teeth 10” carbide tipped saw blade.
For the home wood worker, this is a good tool that gives you a wide variety of tools with a relatively small foot print.
Did you enjoy this article? Why not leave a comment below and continue the conversation, or subscribe to my feed and get articles like this delivered automatically to your feed reader.
Comments
No comments yet.
Leave a comment